Factory direct since 2019 · OEM & ODM · EXW / FOB / CIF / DDP Sales reply within 6 hours

Cartridge Guns, Caulking Guns & Dual Component Applicators

Applicators for one-component sealants and two-component structural adhesives, in aluminium or powder-coated steel. Every ratio family we stock — 1:1, 2:1, 5:1 and 10:1 — is covered by a gun and a matching cartridge, so a line can be tooled from one supplier. Buyers looking for a dual cartridge gun, an AB glue gun or a heavy-duty caulking gun are all in the same place: the frame carries the thrust, the cradle carries the ratio.

Selection guide

How to choose dispenser guns

Pick the ratio first

The cartridge ratio decides the gun. 1:1 for most epoxy and PU adhesives, 2:1 for fast-cure acrylics, 10:1 for low-catalyst systems. A convertible cradle covers two families and cuts tooling spend.

Match the frame to duty cycle

Powder-coated steel suits occasional assembly; anodised aluminium with hardened stainless rods holds up on three-shift lines with abrasive fillers.

Check the thrust

Thick structural pastes need 3 kN and above. Below that the trigger effort per shot climbs and operators start short-stroking the cartridge.

Buyer questions

Frequently asked questions

What is the difference between a cartridge gun and a caulking gun?

A caulking gun pushes a single tube or sausage pack of sealant. A cartridge gun drives a dual cartridge with two barrels, so the A and B components advance together at a fixed ratio. The confusion is common because both are trigger-operated: if the pack has one bore it is a caulking gun, if it has two bores side by side it is a dual cartridge gun.

What thrust ratio do I need for a 400 ml epoxy cartridge?

A 26:1 mechanical advantage is the usual choice for structural pastes and filled epoxies in 400 ml side-by-side cartridges. Lower-viscosity adhesives dispense comfortably on a lighter frame, but a low ratio on a thick paste makes the trigger hard and the bead uneven, because the operator short-strokes under load.

Can one gun run both 1:1 and 2:1 cartridges?

Only if the cradle is convertible. On a fixed-ratio gun the two rods are sized for one ratio, so a 2:1 cartridge will not seat. Our convertible 50 ml model takes both families and is the cheaper way to cover a mixed adhesive list.

Which cartridge sizes does the range cover?

50 ml dual cartridges, 310 ml single tubes, 400 ml side-by-side cartridges and 600 ml packs. Each size has its own frame, so tell us the cartridge first and the gun follows.

Need a drawing matched, not a catalogue part?

Send the cartridge, adhesive datasheet or sample and we will confirm the matching part, tooling cost and lead time in one reply.

Request a quote