Factory direct since 2019 · OEM & ODM · EXW / FOB / CIF / DDP Sales reply within 6 hours

Empty Dual Cartridges, 2K Barrels & PUR Tubes

Packaging that holds the mixing ratio while the adhesive is stored, shipped and dispensed. Barrels are moulded in-house, so bore tolerance, piston fit and print position stay inside one process instead of being assembled from three suppliers. Whether you call it an empty dual cartridge, a side-by-side 2K barrel or an AB cartridge set, the two things that decide whether it works are the bore and the piston seal.

Selection guide

How to choose cartridges & barrels

Ratio accuracy is the whole job

A 400 ml 1:1 barrel that drifts to 55:45 delivers the wrong cure. We hold ±1.5% by weight on the piston stroke, checked per batch.

Material follows the chemistry

PP for epoxy, PU and acrylic; aluminium with internal lacquer for moisture-cure PUR, where a PP wall would let water vapour through.

Plan the private label early

Custom colour and print start at 5,000 pcs. Sending artwork with the order instead of after it saves a two-week round trip.

Buyer questions

Frequently asked questions

What does the system letter on a cartridge mean?

Cartridge families are sold by interface letter — A, C, F and similar — and the letter describes the outlet and the way the mixer locks on, not the volume. Two 400 ml cartridges with different letters take different mixers. Photograph the outlet and the letter moulded on the flange, send it with the order, and we match the interface rather than guessing from the volume alone.

What is a side-by-side cartridge?

Two barrels moulded side by side with a shared outlet, one for resin and one for hardener. The ratio is set by the bore difference between the two barrels, so a 1:1 cartridge has equal bores and a 10:1 cartridge has a much smaller B side. Coaxial cartridges put the small barrel inside the large one and are a different animal.

Can I fill empty cartridges with my own adhesive?

Yes, that is the normal use. Fill from the open end, fit the piston, then close with the cap. Degas or centrifuge afterwards if the adhesive traps air, otherwise the bubbles show up as voids in the bead.

Do you print our brand on the barrel?

Custom colour, print and ratio marking start at 5,000 pcs per size. Below that we supply neutral stock barrels. Send artwork as AI or PDF with the order and print position is confirmed on a proof before production.

Need a drawing matched, not a catalogue part?

Send the cartridge, adhesive datasheet or sample and we will confirm the matching part, tooling cost and lead time in one reply.

Request a quote